Plot > Surface Components > δn   Normal Displacement (Closure)

Contours the closure or normal displacement occurring on DD elements.

This component can be accessed via the Strength Factor Components toolbar as follows:

This toolbar can be changed to a vertical orientation by dragging is against either the right or left hand edge of the main window.

It can be changed back to a horizontal orientation by dragging is against either the top or bottom edge of the main window.

Selecting the button on the Contours toolbar activates the Surface Components toolbar.

Note that there are three components of closure that can be contoured:

Plot > Surface Components > Value > Elastic

Plot > Surface Components > Value > Plastic

Plot > Surface Components > Value > Total

The contour range is set using

Plot > Range

This component can be added to the contour toolbar if desired

Tools > Configure Contouring Toolbar

Related Topics:

Plot > Surface Components > ds - Shear Displacement (Ride)