Plot > Surface Components > Coh - Cohesion

  Plot > Surface Components > Phi - Friction Angle

Contours the Cohesion and Friction angle of the gouge material.

These components can be accessed via the Strength Factor Components toolbar as follows:

This toolbar can be changed to a vertical orientation by dragging is against either the right or left hand edge of the main window.

It can be changed back to a horizontal orientation by dragging is against either the top or bottom edge of the main window.

Selecting the button on the Contours toolbar activates the Surface Components toolbar.

This is of particular interest when you use the Equilibrated-Gouge material type since the cohesion and friction angle can vary from place to place..