ID_BUILD_UNDO   CAD > Build > Undo Point

Top  Previous  Next

During block construction, points are selected in sequence. This allows points to be unselected during construction of the following entities:

 

ID_BUILD_BLOCK CAD > Build > Block

 

ID_BUILD_FFLOOP CAD > Build > FF Loop

 

ID_BUILD_DDLOOP CAD > Build > DD Loop

 

tline CAD > Build > Tunnel

 

ID_BUILD_GPLANE CAD > Build > Grid Plane

 

ID_BUILD_GLINE CAD > Build > Grid Line

 

ID_BUILD_CLINES CAD > Build > Construction Lines

 

Any unselected points can be reselected using

 

ID_BUILD_REDO CAD > Build > Redo Point

 

Once you have completed block construction, you can undo this and remove this block from the model database by selecting (10 levels of undo/redo are supported)

 

ID_BUILD_UNDO CAD > Build > Undo Build

 

You can then redo the block construction. This allows you to repeat any trial meshing operation.

 

ID_BUILD_REDO CAD > Build > Undo Redo