|
Top Previous Next |
Contours the normal strain occurring in the in-filling material of DD elements. This component can be accessed via the Strength Factor Components toolbar as follows:
This toolbar can be changed to a vertical orientation by dragging is against either the right or left hand edge of the main window. It can be changed back to a horizontal orientation by dragging is against either the top or bottom edge of the main window.
Selecting the
The normal strain is determined by dividing the normal displacement (closure) by the DDplane thickness
Note that there are three components of strain that can be contoured:
The contour range is set using
This component can be added to the contour toolbar if desired
Related Topics:
|