Plot > Surface Components

Activate the surface components toolbar – after Map3D BEM analysis.

This toolbar is meant to provide quick access to the surface component plots.

Plot > Surface Components > Serr Stress Error

Plot > Surface Components > Ferr Failure Error

Plot > Surface Components > Ts Shear Stress

Plot > Surface Components > Sn Normal Stress

Plot > Surface Components > Es Shear Strain

Plot > Surface Components > En Normal Strain

Plot > Surface Components > Ds Shear Displacement (Ride)

Plot > Surface Components > Dn Normal Displacement (Closure)

Plot > Surface Components > Strength/Stress

Plot > Surface Components > dTs Excess Shear Stress

Plot > Surface Components > dEs Incremental Shear Strain

Plot > Surface Components > dTs / dEs Stress/Strain rate

Plot > Surface Components > Temperature/Head

Plot > Surface Components > qn Normal Flux

Plot > Surface Components > Value > Elastic

Plot > Surface Components > Value > Plastic

Plot > Surface Components > Value > Total

Notes:

The surface components toolbar can only be activated after the model building - CAD Stage

Map3D Analysis Stages

Any of these components can be added to the contour toolbar if desired

Tools > Configure Contouring Toolbar